Table of Contents
Advertisement
2.4 Locating Connectors (solder side)
2.5 Setting Jumpers
You may configure your card to match the needs of your application by
setting jumpers. A jumper is a metal bridge used to close an electric cir-
cuit. It consists of two metal pins and a small metal clip (often protected
by a plastic cover) that slides over the pins to connect them. To "close" a
jumper, you connect the pins with the clip. To "open" a jumper, you
remove the clip. Sometimes a jumper will have three pins, labeled 1, 2
and 3. In this case you would connect either pins 1 and 2, or 2 and 3.
Figure 2.2: Connectors (solder side)
11
Chapter 2
Advertisement
Table of Contents
