Audiovox PRO9276C Installation Manual page 7

Vehicle security system with remote start pursuit series

Hide thumbs Also See for PRO9276C:

( when used ) and the neutral safety switch as shown in the following diagram.

Failure to connect this wire to the ignition switch side of the of the neutral safety switch can result in

personal injury and property damage.

SEE NEUTRAL START SAFETY TEST FOR FURTHER DETAILS.

YELLOW START WIRE DETAIL

6 GREEN Wire: Ignition 2 Output

Connect this wire to the ignition 2 wire from the ignition switch. This wire will show + 12 volts when the

ignition key is turned to the "ON" or "RUN" position and is some cases the "START" or CRANK" position.

This wire will show 0 volts when the key is turned to the "OFF" and "ACCESSORY" positions.

NOTE: See programming information (Bank 3 Selection #2) concerning this wire to allow output during the

"START" mode.

WIRING THE 4 PIN ALTERNATE IGNITION HARNESS

PART # 1123743

Note: Do not remove the fuse holders from this wire harness. Fuses must be

used and located as close as possible to the power source for adequate protec-

tion of the vehicle.

1 ORANGE/BLACK Wire: Parking Brake Input

This wire is used only when the turbo timer mode, Bank 3, feature # 16 is selected ON. This input insures

that the vehicle parking brake is applied whenever the vehicle is set up for and the turbo timer circuit is used.

This input must switch to ground when the vehicle's parking brake is applied. Connect the Orange/Black wire

to the negative output of the vehicle's parking brake switch.

2 N/C

This cavity of the connector is empty

3 RED/BLACK Wire: + 12 Volts Input

Note: The Red/Black and Pink are dry contacts and may be used for negative switching when necessary.

Connecting the Red/Black to chassis ground will result in Pink being ground when the R/S is activated.

This input is to be connected to a separate, (Other than the wire Red or Red/White is connected to), constant

on + 12 volt source which will supply + 12 volt power to the additional ignition output, (Pink), wire. Connect

this wire to a separate + 12 Volt source.

4 PINK Wire: Additional Ignition Output

This wire can be used as an additional + 12 Volt ignition output supplied by the Red/Black wire. This output

can be selected to be on or off during the start cycle. (See feature bank 3 selection # 8) Connect this wire

to the third ignition circuit in the vehicle and set the selectable feature # 8 of Bank 3 according to the way in

which the vehicle's ignition switch operates.

128-8784b

7 of 28