Installation Instructions This Unit Is Intended For Installation In Vehicles With 12 Volt Negative Ground Electrical Systems Only Kit Contents: PRO 9842 Control Module (2) - Two Button Transmitters 2 Channel Code Learning Receiver (1) - Multi Pin Input/Output Harness...
The PRO 9842 Vehicle Alarm System is designed to provide a basic deterrent to vehicle theft, and a convenient electronic means to gain access to the vehicle by providing RF remote control over the vehicle's power door lock system. The unit also includes outputs to control the vehicle's parking lights, and an additional auxiliary output designed to allow for control over an optional device such as a power trunk release or engine starting device.
RED Wire (Connects to RED/WHITE wire at harness plug): Main Power Input Wire These are the main power input wires for the PRO 9842 system. Both wires connect to a separate fuseholder contained in the harness. These fuseholders each hold a separate ATC fuse, one 5AMP and one 15AMP.
Page 4
BLACK Wire: Main System Ground This is one of the most important wires of the PRO 9842 installation. It must be connected properly to a solid chassis ground it will help ensure reliable system operation. Special care must be taken to locate a clean metal part of the chassis as an attachment point for this wire.
Page 5
4 WIRE POLARITY REVERSAL and 5 WIRE ALTERNATING DOOR LOCK CONTROL CIRCUITS: In these applications, the AS-9159 Door Lock Interface (or equivalent 30 Amp. automotive type relays) must be used. Refer to the Audiovox Door Lock Wiring Supplement for proper connection to these types of circuits. þù...
Route the Black and Grey wires from the Valet/Program/Manual Override switch to the PRO 9842 unit and plug the blue 2-PIN connector into the mating blue connector shell of the PRO 9842 control module. Do not force the connector, it will only plug in one way. Note: Please refer to the section;...
1 of the transmitter will cause the system to produce 2 Chirps. This signifies that you have changed the programming to Chirps OFF. Please follow the programming procedure carefully, and refer to the list of the Programmable Features above when programming the PRO 9842. 1 Chirp...
ÿ COMPLETING THE INSTALLATION: After you have confirmed the operation of the PRO 9842, and tested any and all optional features of the system: 1. Mount the control module up and behind the dash securing it in place with cable ties or screws. Be certain that the chosen mounting location will not inhibit any of the controls of the vehicle.