Delta TS350 Instruction Manual page 16

6. Align the hole in the blade guard and splitter assembly (E) Fig. 29 with the hole in the splitter bracket (C).
NOTE: Make certain that the two protrusions (pins)(G) Fig. 30 are engaged with the channel of the splitter assembly.
7. Place a 1/4" external tooth lockwasher and a 5/16" lockwasher on an M6 x 1 x 20mm hex head screw. Insert the
hex head screw (D) Fig. 29 through the hole in the support bracket, then through the slot in the blade guard/splitter
assembly.
8. Place a 1/4" external tooth lockwasher and a 5/16" lockwasher on an M6 x 1 x 20mm hex head screw (D) Fig. 29.
Thread an M6 x 1 wing nut (F) Fig. 30 on the end of the hex head screw.
NOTE: Before tightening the wing nut (F) Fig. 28, leave at least a 1/8" gap between the bottom edge of splitter (N) and
top surface of table (P).
D
9. Use a straight edge to see if the splitter (E) Fig. 31 is
aligned with the saw blade (R). To adjust, loosen the
nut (A) Fig. 31 and move or rotate the splitter (E).
RIP FENCE HOLDER BRACKET
Attach the rip fence holder bracket (A) Fig. 32 to the right side of the saw cabinet using two M5 x 12mm sheet metal
screws and two M5 lockwashers.
MITER GAUGE BRACKET
Use four M5 x 12mm sheet metal screws and two M5 lockwashers to attach the miter gauge holder bracket (A) Fig. 33
and the wrench holder bracket (B) to the left side of the saw cabinet.
Fig. 32
C
E
Fig. 29
A
16 - English
N
G
R
Fig. 31
B
Fig. 33
P
F
Fig. 30
E
A
A