Programming Bank 2 Alarm Features - Prestige Platinum APS-901C Installation Manual

The transmitters are pre-programmed from the factory, If you find you need to program new or additional
transmitters follow the instructions below.
PROGRAMMING BANK 1 (TRANSMITTERS):
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Press the Button of each transmitter you want programmed until you hear the parking light relay click.
4) Turn the ignition switch off.
The above action programs the Start/Unlock buttons of the system.
PROGRAMMING BANK 2 (ALARM FEATURES):
You can enter bank 2 from bank 1 by turning the ignition key off then on from step 4 of Bank 1.
(Siren Short then Long Chirp), or You can also go right to bank 2 by:
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times. (Siren Chirps)
3) Turn the ignition key off then on. (Siren Short Then long Chirp)
4) Press the pushbutton switch once to advance to feature 1, twice to advance to feature 2, etc,,,then
use the lock button of the transmitter to select the feature setting.
Example to set door lock output to double lock & unlock pulse:
1) Turn the ignition key to the on position.
2) Press and release the valet/programming switch 3 times. (Siren Chirps)
3) Turn the ignition key off then on. (Siren Short Then long Chirp)
4) Press the pushbutton switch once to advance to features 1, Door Lock/Unlcok Timing, then use the lock
button of the transmitter to select five chirps "Dbl L, DBL U/L".
5) To exit the programming mode, turn the ignition key off. The program mode is automatically exited when
there is no activity on the pushbutton switch or the transmitter lock button.
16
128-8801b
16 of 20