Prestige Platinum APS-901C Installation Manual page 7

7 Gray Wire: Negative Inhibit Input 1
Connect the GRAY wire to the previously mounted hood pin switch provided. This wire will be routed through the firewall
into the engine compartment. It is necessary to use an existing grommet when passing wires through the firewall
to prevent short circuiting. This is an important safety feature of the System, failure to use this feature can result in
serious injury. Route the wire to the pin switch and connect it using the bullet connector provided.
8 Brown Wire: Positive Inhibit Input 1
Any time + 12 Volts is applied to the Brown wire, the Remote Starter will stop operating, even if the signal is received
from the transmitter.
If the vehicle has a factory installed hood pin switch and that switch provides + 12 Volts to an under hood light, the
Brown wire can be connected to the existing pin switch.
9 Brown w/ Black Wire: Positive Inhibit Input Plus Trigger When Armed
The Brown w/ Black Trace wire provides an instant shutdown for the Remote Start Control module whenever it gets
+ 12 volts also triggers the alarm when armed. If the Brake lights switch in the vehicle switches + 12 volts to the
brake light circuit, connect the Brown w/ Black trace wire to the output side of the brake switch. This will allow the
Remote Start to shut down if an attempt is made to operate the vehicle without the key while running under the
control of the Remote Start. In most vehicles, in order to shift into gear, the brake pedal must be depressed. The
brake input will in turn cause the remote start unit to shut off.
10 No Connection
11 White Wire: Parking Light Flasher Output
This wire is the normally open contact of the on board parking light flash relay. Connect this wire to the vehicle's
parking light feed wire. This is the wire that gets switched on, either (+) or (-), when the vehicle's parking light switch
is activated.
12 White Wire: Parking Light Flasher Input
This wire is the common contact of the on board parking light flasher relay. If the vehicle you are working on has +12
volt switched parking lights, connect this wire to a fused + 12 volt source. (Max. 15 Amps)
NOTE: If the vehicle's parking lights are ground switched, connect this wire to chassis ground.
7
128-8801b
7 of 20