HP DMXTM 400/430 Operator's Manual page 62

Copy Module:
Metric:
Print Test Label:
System Test Label:
Edit Module Name:
Reset Printer:
Exit To RS-232C System:
Pack Module Data:
52
Creating Labels Using Internal Batch Software
Copies graphic images and/or label
formats from one memory module to
another. Be certain that the write protect
switch is 'on' for the source module and
'off' for the destination module.
Each time the number 3 is pressed, the
screen will toggle between metric 'No'
and metric 'Yes'.
Prints a Printhead Test Label and is used
as a relative gauge of Printhead condition
and wear.
Lists all current Printer settings and
checks both ROM and RAM. Prints a
Printhead test label after the system test.
This will allow you to change the name of
the module.
This is the same as the <SOH #>
command in the standard printer mode. If
switch 7 is on then the internal batch will
take over.
This is the same as turning Switch 7 'off'
and resetting the Printer. You can use the
<STX g> command to enter the Internal
Batch without using switch 7 in the rear
of the Printer.
All the label formats are stored in a 256K
flash module; therefore, only the entire
module can be cleared. For this reason,
the data will occasionally need to be
packed from time to time when the
memory becomes low.
DMX 400/430 Operator's Manual