HP DMXTM 400/430 Operator's Manual page 39

To format the module hit "I" and the following screen will appear:
MODULE MEMORY TEST AND FORMAT
WARNING !! MODULE DATA WILL BE LOST !!
PLUG IN MODULE. PRESS ENTER (Esc TO CANCEL)
Hit "Enter" to begin formatting the module, the following screen will
appear:
MODULE MEMORY TEST AND FORMAT
WARNING !! MODULE DATA WILL BE LOST !!
MODULE UNDER TEST PLEASE WAIT !!
ppppppppvvvvvvvv
MODULE MEMORY IS GOOD
PRESS ENTER TO TEST ANOTHER "Esc TO EXIT"
once the module has been formatted, hit "Esc" to enter the Internal
Batch Mode.
Note: Use a small screwdriver to turn the module's write protect
switch to the 'off' position. Label formats cannot be sent
to the module if the switch is in the 'on' position. To
prevent accidental changes or modifications to formats,
turn the write protect switch back to the 'on' position.
4. Verify Setup, Power Up, and Load Media
Check that all connections are made and that DIP Switch S1 is
correctly configured. Turn on the CRT and Printer power switches.
Press the F1 key on the CRT several times. The create/modify label
screen and print label screen should toggle back and forth. If this
does not happen, re-check the CRT settings, check the interface
cable. If the screens still do not appear, contact your local
representative. If the Module has not been formatted for Internal
Batch, the set up screen will appear until you hit the I option. If
steps 1-4 have been successfully completed, load the Printer with
media.
DMX 400/430 Operator's Manual
Creating Labels Using Internal Batach Software
29