Table of Contents
Advertisement
A. MCS-2160 Telnet Command – system
Command Descriptions – system
show
user
The system save command allows you to save the current settings to MCS-2160's
save
NV-RAM. Please note that all unsaved settings will be lost after system reboot.
Logip
system
safety
update
The system reset command allows you to reset all MCS-2160's settings back to the
reset
default values.
The system reboot command allows you to reboot MCS-2160. Please note that all
reboot
unsaved settings will be lost after rebooting.
*Note1: Please access the "Counter" by entering "sys show chassis". Entering "0" to access the MCS-2160, than enter the
number of the slot of the module card that you want to analysis, and please confirm the commands for specific analysis.
*Note2: For updating your MCS-2160, please update first all the MGM_RTC_v1.1b002 version, and than update to the
MGM_RTC_v1.1b003 or newest.
XTRAMUS TECHNOLOGIES
The system show allows you to view MCS-2160's Fan Tray status,
chassis
PCB/firmware/FPGA versions, as well as hardware temperature and
Counter of each module card.
The system show information command display the S/N, MAC, PCB
information
version and Firmware version of your MCS-2160.
fant
Shows the detail information of your connected MCS-FANT.
The system user show command allows you to view the current
show
users and their passwords.
The system user admin [name | password] <name | password>
command allows you to change the user name and its password of
admin
the user with administrator privilege. For example, if you type in
system user admin name test123 and press enter, a user named
test123 with administrator privilege will be created.
The system user guest [name | password] <name | password>
command allows you to change the user name and its password of
guest
the user with guest privilege. For example, if you type in system user
guest name test123 and press enter, a user named test123 with
guest privilege will be created.
This command will show your current Syslog Receiver IP.
Show
You can set your Syslog Receiver IP by typing command: sys logip
Set
set xxx.xxx.xxx.xxx .
This command will show you the status of this function and the set
show
temperature threshold.
enable
This command will enable the safety function.
disable
This command will disable the safety function.
This command allows you to set the temperature threshold. You can
value
set as 60, 65, 70, 75 and 80 degrees centigrades.
The system update [firmware/fant] [remote file] [host ip]
commands allow you to upgrade MCS-2160's firmware/fant. The
following descriptions are for upgrading MCS-2160's firmware.
However, procedures for upgrading MCS-2160's fant are quite the
same and can be related.
1. Please download and install first the Tftpd32 software from
internet.
firmware/fant
2. Let the BIN file (firmware update file) inside a folder of your PC,
and open this file by open the folder with Tftpd32.
3. Set the Server Interface of Tftpd32 as 192.168.1.17.
4. On the Hyper Terminal screen, type in "sys update
[firmware/fant] [remote file] [host ip]" and click enter. Press Y
to proceed and start upgrading firmware, or press N to cancel.
5. MCS-2160 will reboot when finishing upgrading the firmware.
®
74
E-mail: sales@xtramus.com
Website: www.Xtramus.com
Advertisement
Table of Contents
