System Module Card - Xm-M667 - Xtramus MCS-2160 User Manual

B. System Module Card – XM-M667
The XC-M667 comes with your MCS-2160 chassis, and shall be installed on the Mgm slot located on
the far right side of MCS-2160 chassis. This module card allows you to manage MCS-2160 chassis
via management webpage.
To access the Management Web Page of MCS-2160 for configuration on your browser, please
connect a RJ45 cable between the Management port of MCS-2160 and your PC.
To configure MCS-2160 on your PC (Telnet or Hyper Terminal), please connect a 2.5mm Phone Jack
to RS232 between your PC and Console Port of MCS-2160, where the 2.5mm Phone Jack end must
be plug in the Console Port of MCS-2160 and the RS232 end must be connect to your PC.
Interface Ports
Console Port
Management Port
LED
Green ON
Power
Green OFF
Yellow ON
Green ON
Sys
(Blinking)
Green OFF
Master User defined LED
Remote User defined LED
*Note: XC-M667 does not support hot-swap. Please do not draw the XC-M667 module card from MCS-2160
chassis when the system is power on.
XTRAMUS TECHNOLOGIES
One 2.5mm Phone Jack Port for managing MCS-2160 via HyperTerminal
One 10/100M RJ45 Port for managing MCS-2160 via management webpage
XC-M667 is power on
XC-M667is power off
XC-M667 is booting and preparing for test
XC-M667 is booting properly and is ready for test
XC-M667 is power off
®
14
E-mail: sales@xtramus.com
Website: www.Xtramus.com