Setting Up Your Phone; What You'll Need; Assembling The Phone - Cisco 525 Administrator's Manual

SETTING UP YOUR PHONE

What you'll need

Before you begin installing your service, please make sure you have the following equipment:
A Cisco 525 phone body.
A handset and cord.
A desk stand.
A CAT 5 Ethernet computer cable, to connect the phone to your router.
A power supply unit, including a plug lead and clip, assuming you're not using Power Over
Ethernet switches or ports.
A sheet with your phone number, online account user details and voicemail PIN - this is
important information, so please keep it somewhere safe, even after set-up.
A working Ethernet LAN with Ethernet broadband router - USB routers and modems are not
compatible.
A Power over Ethernet switch - or Ethernet switch - depending on your installation.

Assembling the phone

Now, start by putting the phone together in the following order:
First, find the coiled handset cord. Plug it into the smaller socket on the underside of the phone -
this is marked with a phone symbol.
Now, take the other end of the handset cord and plug it into the handset.
Line up the phone stand and the tabs with the slots on the underside of the phone. Slide the
bottom tabs into the slots and press lightly down on the top of the desk stand - don't force it.
Next, push the power brick into the plug unit and plug the power lead into the phone, to
assemble the power supply unit. ONLY IF YOUR NOT USING POE AND HAVE ORDERED
THE ASSOCIATE PSU.
Connect the computer cable to the underside of the phone in the socket marked SW.
Nomis Connections, Connections House, 11a Kings Road, Fleet, Hampshire, GU51 3AA
0844 880 9900 0844 880 0009 sales@nomisconnections.co.uk www.nomisconnections.co.uk | www.businessvoipsystems.co.uk