Setting Into Operation - Omnitronic VHF-450 User Manual

5 SETTING INTO OPERATION

5.1 Installing the receiver
Install the receiver on a plane surface or in your rack. For 19" (483 mm) rack installation, 1 unit is required.
Screw on the two supplied mounting brackets at the left and right sides of the housing. When mounting the
unit into the rack, please make sure that there is enough space around it so that the heated air can be
passed on. Steady overheating will damage your device. You can fix the unit with four screws M6 in the rack.
5.2 Connecting the receiver
1 Insert the two supplied antennas into the BNC jacks and put them in a vertical position.
2 Connect the receiving unit to the subsequent unit (e.g. mixer, amplifier):
• Use the balanced XLR outputs "CH A" and "CH B" for connection to balanced microphone inputs.
• Use the unbalanced 6.3 mm jack outputs "CH A" and "CH B" for connection to unbalanced microphone
inputs or highly sensitive line inputs.
• Use the unbalanced 6.3 mm jack "MIX" for the master signal of both receiving channels, for connection
to a microphone input or a highly sensitive line input via the supplied connection cable.
3 Connect the power supply unit to the DC IN jack of the receiver and the mains plug to a mains socket.
Use the receiver only with the supplied power unit. Always disconnect the mains connector when you
wish to change connections, move the unit to a different place or if it is not used for a longer period.
18/21 00042241.DOC, Version 1.3