Hand Wheel Handles; Basic Controls - Craftex CX704 User Manual

HAND WHEEL HANDLES

Thread the handles into the longitudinal and
tailstock handwheels and tighten using a
screw driver and an open wrench. See
figure-2 & 3.
Figure-2 Installing the tailstock hand wheel
handle
Figure-3 Installing longitudinal hand wheel
handle
The cross slide feed handle comes installed
with the opposite direction for shipping
purposes. Remove the cap srew using a
hex wrench and turn the handle around.
Secure the handle by retightening the cap
screw. See figure-4.
Figure-4 Installing the cross feed hand
wheel handle

BASIC CONTROLS

This section describes the basic controls of
the CX704. Use the figure and read the
descriptions to understand
controls of this lathe.
Figure-5 Control panel
A. FUSE SOCKET: Features a 5 Amp
system fuse.
B. VARIABLE SPEED CONTROL KNOB:
Controls the spindle speed range from 0 -
2500 RPM.
the basic
9