Connecting To Gas - AGA COMPANION Owner's Manual

CONNECTING TO GAS

This cooker can be installed with an approved appliance flexible connection. Supply piping
should not be less than R 1/2 (1/2" BSP). Connection is made to the R 1/2 (1/2" BSP) female
threaded entry in the inlet block located just below the hotplate level on the rear left hand side of
the cooker.
Check for gas soundness after connecting the gas supply.
TERMINAL BLOCK
COVER
Fig. 3 DESN 511751
The gas bayonet connector must be fitted in the shaded area indicated in Fig. 3A . Take into
account that it must be possible to pull the cooker forward sufficiently. Ensure flexible hose is not
trapped between electrics cover and rear wall. Ensure hose is routed within shaded area, and
away from shielded oven vent.
The flexible hose must be in accordance with the relevant standards.
NOTE: FOR L.P.G. APPLIANCE
The flexible hose must be suitable for use with Propane gas, capable of 70°C temperature rise,
and carry a red stripe, band or label. If in doubt contact your supplier.
9