How To Assign User Codes And Attributes - Honeywell ADEMCO VISTA-12A User Manual

How to Assign User Codes and Attributes

Refer to the User Setup chart at the back of this manual to keep a record of user programming.
NOTE: Partition Master codes apply only to those user numbers previously assigned (by the system master/
installer) to the partition master's partition.
Add User Code:
( User 03 is preset to be
a partition 1 programmer,
but can be changed.)
Delete User Code:
Authority Level:
Factory Assignments:
(Users 04-17 = 0
user 03 = 4)
Access Group:
Factory Assignments: none
User's Partition:
Factory Assignments:
Part. 1 = users 03-17
RF User Number:
Factory Assignments: none
rm/Disarm Report:
A
System/Partition Master code + [8] + user no. + new user's code
User 01 = installer
User 02 = master
User 03 = partition 1 master
The Keypad beeps once to confirm that new user was added.
System/Partition Master code + [8] + [user no.] + [#] + [0]
The user code and all attributes* programmed for this user number, including any
associated RF keys, are erased from the system. (*except assigned partition)
System/Partition Master code + [8] + [user no.] + [#] + [1]+ auth. level
Authority Levels (see definitions above):
0 = standard user;
1 = arm only;
2 = guest;
3 = duress;
4 = partition master
System/Partition Master Code + [8] + [user no.] + [#] + [2]+ group (1-8)
You can assign users to a group, then set an access schedule that defines the times this
group of users can operate the system. The system does not allow these users to control
the system outside the scheduled times.
System Master Code + [8] + [user no.] + [#] + [3] + [0] + partition(s) + [#]
This command assigns the partitions the user can access. If more
than one, enter partition numbers sequentially, then press [#] to end.
E.g., master code + [8] + [user no.] + [#] [3] + [0] + [1] [2] + [#] gives
the user access to partitions 1 and 2.
Partition Entries: 1 = partition 1; 2 = partition 2; 3 = common partition
Master/Part. Prog. Code + [8] + [user no.] + [#] + [4]+ zone no.
Use this command to assign a wireless button device (keyfob) to this user (keyfob
must be enrolled in system first; see installer).
Zone number: Enter the zone number assigned to the desired function button on the
keyfob that will be used by this user. Each button was assigned a unique zone
number. See your installer for appropriate zone numbers.
Master/Part. Prog. Code + [8] + [user no.] + [#] + [6] + 0 or 1
You can program a user so that a message is sent to the monitoring station whenever
this code is used to arm or disarm the system. 1 = send arm/disarm report; 0 = no
arm/disarm reporting for this user
– 19 –