Advanced System Functions; Accessing Other Partitions - Honeywell ADEMCO VISTA-12A User Manual

Hide thumbs Also See for ADEMCO VISTA-12A:

Installation and setup manual (112 pages)

Table Of Contents

Table of Contents

Accessing Other Partitions

• Each keypad is assigned to a partition by your installer and is used to perform functions in

Partition

Basics

that partition and display that partition's system status.

• Certain users, if authorized, can "GoTo" another partition from their partition's keypad to

perform functions in the other partitions or display another partition's status. See GoTo

command below.

• Certain users, if authorized, can arm/disarm all partitions with a single command from

their home partition. See Multi-Partition Arming below.

• Your system may have been set up to use a common area, which is an area shared by users

Common Area

of the other partitions, such as a foyer or lobby.

• If a common area is part of the system and one of the partitions is armed, faults occurring

in the common area will be displayed on its keypads and the disarmed partition's keypads.

• The common area will be armed and will sound and report alarms only when both the

other partitions are armed; if either of the other partitions is disarmed, the common area

remains disarmed and ignores faults.

• Either partition can arm its system if the common area is faulted, but once armed, the

other partition will not be able to arm unless the faulted common area zone is bypassed or

the fault is removed.

• Either partition can clear and restore the common area after an alarm.

• Entry/exit time for the common area is the same as for partition 1.

• Security code + [∗ ∗ ∗ ∗ ] + partition number (0,1,2, or 3), where:

GoTo

Command

• You can only "GoTo" those partitions that were assigned to you.

• Can only be performed using an Alpha keypad.

• The keypad remains in the new partition until directed to go to another partition, or until

it automatically returns to the original partition (after 2 minutes with no keypad activity).

• Security code + [0] + arming command (2, 3, 33, 4, 7, or 1), where:

Multi-Partition

Arming

• You can use this feature only if you were given that authority.

• You must use an Alpha keypad.

• The system arms only if all partitions are "ready to arm" (unless the system is

programmed to allow arming with faults in certain zones); if any partition is "not ready,"

the system does not arm at all.

• You can use the GoTo command to bypass open zones before arming, if desired.

• If any partition is already armed when multi-partition arming is attempted, that partition

remains in its existing armed state.