Defining Macro Keys
• Only the system master can define macros.
Macro Key
• A macro key is a convenience key that can activate up to 16 keystrokes.
Rules
• Typical functions include arming sequences, bypassing zones, or turning on/off electrically
operated devices.
• Two macros can be assigned in the system, but only to keys pre-programmed by the
installer.
• System Master Code + [#] + [6] [6]
To Define
• Follow the prompts.
Macro Keys
• Enter the macro number (1-2; see installer for appropriate macro number) to be
programmed at the "Select Macro?" prompt.
NOTE: The two macros that can be defined can be made partition specific.
• If a macro has been previously defined, the keystrokes are shown on the bottom line of the
display, otherwise the display is blank.
To exit this mode (and keep the existing macro definition), press any key except the [∗]
key. The system returns to normal mode.
To define a macro for the selected key, press [∗] and continue with the next prompt.
Enter the first of the series of desired commands, (do not include your user code), then
press/hold the "D" key for at least two seconds to complete the first command. This key
terminates each command, and appears as an "F" in the display as shown:
MACRO PGM
6 0 2 0 3 F # 7 0 1 F 2 F
• Enter the next command, followed by press/holding the "D" key for at least two seconds.
The keypad beeps and displays the keystrokes entered.
•. Repeat until all the desired commands have been entered (up to 16 characters including
the "F"s).
Check your keystrokes before continuing. If you made a mistake, you must start over.
• To exit, press/hold the "D" key for at least two seconds. The display returns to system
status and indicates system is ready.
Schedules
About Schedules
Creating Schedules
1. System Master Code + [#] + [6] [4]
2. Enter a 2-digit schedule number from 01-24.
Press [∗] to continue.
– 14 –
The keypad beeps to acknowledge your input and displays
the command you entered (followed by "F").
• The system provides up to 4 end-user schedules (programmable by master/installer
only), which can control various types of events.
• Each schedule causes a defined event to start and stop (when appropriate) at a
specified time.
• Schedules can be set to automatically repeat at various intervals and set for random
starting, if desired.
1 DISARMED
READY TO ARM
ENTER SCHED NO.
00=QUIT
00