Battery Installation And Removal - Motorola ASTRO Digital XTS 3000 User Manual

Battery Installation and Removal

DO NOT replace the battery in an area labeled "hazardous atmosphere."
If your radio is programmed with volatile-key retention (consult your
service technician), encryption keys will be retained for approximately
The battery is shipped uncharged, and must be charged before use.
Note
Refer to the "Battery Charging and Disposal" section on page 72.
Installing the Battery
1. Turn off the radio and hold it with the
back of the radio facing upward.
2. Insert the top edge of the battery into the
area at the top of the radio between the
radio's case and chassis. Make sure the
three tabs on the radio chassis align with
the three slots under the top edge of the
battery.
3. Rotate the battery toward the radio, and
squeeze the battery and radio together
until the battery "clicks" in place.
Removing the Battery
1. Turn off the radio and hold it so that the release
button on the bottom of the battery is facing
upward.
2. Press downward on the release button so that
the battery disengages from the radio.
3. Remove the battery completely away from the
radio
WARNING
!
To avoid a possible explosion:
DO NOT discard batteries in a fire.
CAUTION
!
30 seconds after battery removal.
Introduction
7