Operational Check
The operational check tests the communication link between the remote control and the
DCT5100. Table 3-3 lists the operational check procedures:
Table 3-3
Operational check
Feature
Testing Procedure
Power on
Press
Tune to the output channel of the DCT5100 (channel 3 or 4).
Scan through the channels using the
Channel Selection
Tune to several channels by entering the channel number using the numeric keys.
Press
Volume Control
lowest level, and to a comfortable level.
Press
If the DCT5100 does not operate properly, refer to Section 5, "Troubleshooting".
to turn on the DCT5100.
POWER
+ or - on the remote control to increase the volume to its upper limit,
VOLUME
to turn the sound off. Press
MUTE
Installation
+ or - keys.
CHANNEL
again to restore the sound.
MUTE
DCT5100 Installation Manual
3-17