Table of Contents
Advertisement
Installing the IR Blaster
To install the IR Blaster:
Fit the transmitter into the mounting bracket (refer to Figure 3-8).
1
Plug the mini-pin connector into the
2
illustrated in Figure 3-9:
Figure 3-9
IR Blaster installed
TO
TV/VCR
CABLE
IN
Remove the adhesive tape cover from the mounting bracket.
3
Position and press firmly to attach the mounting bracket to the IR receiver on the VCR. Be
4
careful to route the wire so that it does not prevent loading tapes.
Checking the IR Blaster
The IR Blaster is now located near the receiver and the VCR can be controlled through the
DCT5100. As a final check, operate the VCR using the remote control from various positions in
the room. If the IR Blaster is obstructing the IR receiver on the VCR, move it slightly.
jack on the rear panel of the DCT5100 rear panel as
IR
AUDIO IN
R
L
SPDIF
ETHERNET
HPNA
IR
R
L
Y
AUDIO
USB
OUT
Refer to text to locate
IR receiver on VCR
Installation
VIDEO
N I
O
T U
IEEE 1394
S-VIDEO
TV
Pass Card
Pb
Pr
OPTICAL
SPDIF
DCT5100 Installation Manual
3-11
DCT 5100
SWITCHED
105-125V
60Hz
CONVENIENCE
4A MAX
OUTLET
500W MAX
VCR
Advertisement
Table of Contents
