Table of Contents
Advertisement
If for example you have set the tuning as indicated in the display shown above, the result
will be as follows:
This is what is played:
...this is what is heard.
N.B.: when the SEMITONES parameter is altered, the result will not be audible until any keyboard key or
keys pressed during the operation are released.
7.4 ADJUSTING THE DISPLAY CONTRAST
From the main Utility page, select the
field by means of the [UTILITY] or [ENTER]
[LCD]
buttons; the display will show the following video page:
where the
parameter allows you to adjust the contrast of the display as
LCD Contrast
appropriate to the visual angle assumed or the level of light in the room where you are.
7.5 ASSIGNING SPECIFIC FUNCTIONS TO THE PEDALS
The connectors on the rear panel allow footswitch type pedals ([FOOTSW.1] and
[FOOTSW.2] PEDAL jacks) and expression pedals ([EXPR.] PEDAL jack) to be connected
to the OB5. You can use the expression pedal to control the general volume of the organ,
while the footswitch type pedals are able to perform functions which can be assigned by
means of the Utilities.
From the main Utility video page, select the
field and press [UTILITY] or
[FOOT SW.]
[ENTER]:
Selecting the
field allows you to select assignment of a specific
[PEDAL
ASSIGN]
function to the footswitch pedals, while the
(Pedal Sequence
[PED.
SEQ.
ADV.]
Advance) field can be used to program a sequence of Presets or Memories to be assigned
to the pedals.
74
Hide quick links:
Advertisement
Table of Contents
