Memory Memorisation - Factory Settings - Viscount DB-5 Operating Manual

informing you that the OB5 is initialising the Presets. On conclusion of the operation, the
display will show the MAIN video page.
N.B.: When a Preset Factory Settings operation is carried out, the setups saved by the user will be lost
irretrievably. To avoid this, save the chosen Presets in specific Memories, and if a Memory Factory Settings
operation is to be performed (see next section), carry out a Bulk Dump (see section 7.2) of the Memories
concerned.
4.5 MEMORY SAVING-FACTORY SETTINGS
As for the Presets, saving and Factory Setting can be carried out on individual memory
locations, or all memories.
If you wish to save the settings you have made during programming of the OB5 parameters,
press the [MEMORY] button for at least two seconds and the display will show:
You can use the field to save your programming in the memory indicated,
Memory WRITE
or in another memory by scrolling through the number of the memory locations using the
[-/NO] and [+/YES] buttons. Pressing [ENTER] starts the memorisation procedure and
the display will show:
by which the OB5 asks you to confirm that you wish to proceed with the memorisation.
Press [ENTER] and the procedure will be completed with display of the following video
page:
56