Viscount DB-5 Operating Manual page 32

which relates to the reception channels for the message arriving on the MIDI IN port.
Since this video page is identical to the previous one (setting of the channels for the
transmission of MIDI messages), refer to the information above for the parameters found
in this video page.
When the [UTILITY] button is pressed to move on to the next video page, the display will
show:
In this page, the user can enable or disable the filters for transmission of MIDI messages.
When a filter is enabled (
set as , the message will not be filtered and will be sent. The filters can be enabled
OFF
for:
: filter for the Control Changes transmitted
- CC
: filter for the Program Changes transmitted
- PG
: filter for the exclusive system messages transmitted
- SysEx
The next page will display the filters for the MIDI messages received:
The procedures and settings are identical to those for the previous page (filters for
messages being transmitted).
The fifth page (accessed using the [UTILITY] button, as usual) allows a Program Change
to be sent as output on the MIDI OUT port:
You can use the
Send PG
Program Change, from 0 to 127, which you wish to transmit. The message will then be
sent when [ENTER] is pressed.
This function is useful when you wish to change a program or a patch in an instrument
connected to the OB5 by MIDI. Sending this message allows the program to be changed
on the receiver instrument without having to make any physical changes to its settings.
) the message concerned is not sent, while if the parameter is
ON
(Send Program Change) parameter to set the number of the
72