How To Select A Memory; Presets Memorisation - Factory Settings - Viscount DB-5 Operating Manual

4.3 HOW TO SELECT A MEMORY

In contrast with the Presets, a given Memory can only be recalled by means of the display.
From the MAIN video page:
press the [MEMORY] button; the last memory selected will be activated and the display
will show:
Alongside the (Volume) parameter, indicating the overall volume of the organ, the
Vol
screen now shows the (Memory) parameter, informing you of the number of the
Mem.
memory activated.
You may use the [-/NO] and [+/YES] buttons on the panel on the left of the manuals to
scroll through all the memories. The LED of the [MEMORY] button will start to flash,
informing you that the Memory is booked but not yet made active. To do this, press [ENTER]
on the panel referred to above and the selected memory will become active. The LED
above the [MEMORY] switch will remain constantly on to inform you that the MEMORY
concerned has been loaded.
This "booking" function is of considerable importance when you are playing with a given
type of sound and wish to use another set of sounds at a specific point in the piece you are
performing. This can be done easily by booking a given Memory and then activating it at
the required point.
4.4 PRESET MEMORISATION-FACTORY SETTINGS
If you wish to save a Drawbar setup in a Preset, press the key for manual operation of the
Drawbars ([UPPER] button for the upper manual or [LOWER&BASS] for the lower manual)
simultaneously with the key of the Preset in which you wish to memorise the new setup.
If you wish to restore the Preset factory settings, i.e. the settings memorised when the
instrument was purchased, you can carry out a Factory Settings (of all the Presets) by
pressing the [UPPER] e [LOWER&BASS] buttons in the PRESET DRAWBARS section
of the front panel simultaneously, when the instrument is switched on. The display will
show:
55