T One F Requency Id S Can - Kenwood TH-255A Instruction Manual

t F
one requency
This function scans through all tone frequencies to identify the
incoming tone frequency on a received signal. You can use this
function to find which tone frequency is required by your local
repeater.
1 Press [F], [2] (1s) to start the Tone Frequency ID scan.
• When the transceiver receives a signal, scan starts. The
decimal point blinks during scan.
• While the transceiver is receiving a signal during Tone Freq.
ID Scan, the signal is emitted from the speaker.
• To reverse the scan direction, rotate the Selector (or press
[UP]/ [DOWN]).
• When the tone frequency is identified, a beep sounds and the
identified frequency blinks.
2 Press [MENU] to program the identified frequency in place of the
current tone frequency.
• Press any key other than [MON], [UP]/ [DOWN] or [ ] to exit
the Scan function.
Note: Some repeaters do not re-transmit the access tone in the
downlink signal. In this case, check the other station's uplink signal to
detect the repeater access tone.
22
id S
cAn