Basic Operations; S Witching P Ower On/Off; A Djusting The V Olume; S Electing A Z One And C Hannel /G Roup Id - Kenwood NEXEDGE NX-700 series Instruction Manual

S p on/oFF
wiTching ower
Press and hold the
power ON. Press and hold the
■ Transceiver Password
If the transceiver is password protected, "PASSWORD" will appear on the
display when the power is turned ON. To unlock the transceiver, enter the
correct password:
1 Select a character using the
• If you are using a microphone keypad, you can enter the password by direclty
pressing the DTMF keys instead.
2 Press the
• This step is unnecessary when using a keypad.
3 Repeat steps  and 2 to enter the entire password.
• Press the
Press and hold the
4 Press the
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
• The password can contain a maximum of 6 digits.
A v
djuSTing The olume
Press the keys programmed with Volume Up/ Volume Down to adjust the
volume level.
S Z
elecTing A one And
Select the desired zone using the keys programmed as Zone Up/ Zone Down.
Each zone contains a group of channels.
Select the desired channel/group ID using the keys programmed as CH/GID Up /
CH/GID Down. Each channel/group ID is programmed with settings for
transmitting and receiving.
Names can be programmed for zones and channels/group IDs. Each name can
contain up to 4 characters.
• You can toggle the display between the zone and channel/group ID names and number
by pressing the key programmed as Display Format, or by accessing the Display Format
function through the Menu {page 2}.

BASIC OPERATIONS

switch for approximately  second to turn the transceiver
switch again to turn the transceiver OFF.
and
key to enter the selected character.
key or microphone # key to delete an incorrectly entered character.
key or microphone # key to delete all characters.
key or microphone
c /g id
hAnnel roup
keys.
key to confirm the entry.
9