Kenwood TH-255A Instruction Manual page 59

• Press [CALL] to delete the character at the current cursor
position.
• On the transceiver display, DTMF code " " is represented
by "E" and "#" is represented by "F".
• You can also enter a DTMF code using the keypad.
Simply enter your desired DTMF codes on the keypad.
5 Press [MENU] to select the DTMF code and move the cursor
to the next digit.
6 Repeat steps 5 and 6 to enter up to 16 digits.
7 To complete the entry, press [MENU] without selecting a
DTMF code. To confirm the stored DTMF code, perform
steps 1 and 2, then press [MON]. The programmed DTMF
code scrolls through the display without transmitting.
8 Press any key other than [MON], [UP]/ [DOWN] or [ ] to exit
Menu mode.
■ T
ransMiTTing a
1 While pressing and holding [PTT], press [MENU].
2 Release [MENU] (continue pressing [PTT]), then rotate
the Selector (or press [UP]/ [DOWN]) to select the desired
DTMF memory channel number.
3 While still holding [PTT], press [MENU] again to transmit the
selected DTMF tones.
• The code stored in the channel scrolls across the display,
accompanied by DTMF tones from the speaker.
• After transmission, the frequency display is restored.
• If you do not need to confirm the memory channel
contents, press [0] ~ [9] instead of turning the Selector
(or pressing [UP]/ [DOWN]) in step 2, to select a channel
number. The stored DTMF code will be immediately
transmitted. (You do not have to press [MENU] in step 3.)
s DTMF c
ToreD oDe
51