F Requency S Tep S Ize; B Ack L Ight - Kenwood TH-255A Instruction Manual

3 Press [MENU] to store the setting.
4 Press any key other than [MON], [UP]/ [DOWN] or [ ] to exit
Menu mode.
F s
requency Tep
Choosing the correct frequency step size is essential in order to
select your exact receive frequency using the Selector (or [UP]/
DOWN). You can select your desired frequency step size from: 5,
6.25, 10, 12.5, 15, 20, 25, 30, 50, or 100 (kHz).
To change the frequency step size:
1 Press [VFO], then press [F], [3].
• The current frequency step size appears.
2 Rotate the Selector (or press [UP]/ [DOWN]) to select your
desired frequency step size.
3 Press any key other than [MON], [UP]/ [DOWN] or [ ] to exit
the frequency step size selection.
Note: If you change to a frequency step size that does not match the
current operating frequency, the transceiver automatically adjusts the
frequency to match the new frequency step size.
B l
ack igHT
To illuminate the display:
Press [ ].
• If no other key is pressed, the light turns OFF approximately 5
seconds after releasing [ ].
Press any key (including [PTT]) other than [ ] while the display
•
is lit to restart the 5-second timer.
• Press [ ] while the display is lit to immediately turn the light
OFF.
To keep the light ON continuously:
58
s
ize