Lens Assembly Installation/Replacement
The Legend™ 4500 comes with 15 lens assembly pre-installed from the factory. However, there is another
optional lens assembly (LLENS3054) available as an accessory, which will alter the beam angle. Please follow
the below instructions for proper replacement/installation.
2. Lens
assembly
1. Front plastic cover
1.
Remove the front plastic rim cover (black), by removing the screws that hold it in place.
There are 8 screws to remove for this step.
2.
After removing the front rim cover, remove the screws that hold the lens assembly in place.
3.
You now should have full access to the lens assembly. This must be removed and the old
lenses must be replaced with the new lenses. The same assembly is to be reinstalled with
the new lenses in place and the process is complete.
Warning!
1. When replacing the lens assembly, please make sure that the power is
disconnected from the fixture beforehand.
2. You must also be VERY CAREFUL when opening this fixture. Improper
handling of this unit may void the warranty if any parts are damaged due to
negligence on behalf of the user.
Legend™ 4500 User Manual
Note: use care when performing this procedure, as this gives you direct access
to the LEDs, which are very fragile.
10
3. LED PCB
12/10/2008 4:28 PM