Lens Assembly Installation/Replacement - Chauvet COLORado 1 VW User Manual

Lens Assembly Installation/Replacement

The COLORado™ 1 VW comes with 30 lens assembly pre-installed from the factory. However, there is another
optional lens kit (CLENS1536), which is the 15 degree assembly. This is available as an accessory, and will alter
the beam angle. Please follow the below instructions for proper replacement/installation.
3. Lens Screws
1. Gel Frame
holder
1.
2.
1.
2.
3.
4.
Warning! 1. When replacing the lens assembly, please make sure that the power is
2. You must also be VERY CAREFUL when opening this fixture. Improper handling
COLORado1™ VW User Manual
Remove the gel frame holder, using a Phillips#2 screwdriver.
Remove the front, glass UV cover (black) by removing the 8 Phillips #2 screws that hold it in
place.
After removing the glass cover, remove the screws that hold the lens assembly in place. There
are 5 Phillips #2 screws that secure this assembly in position.
Note: use care when performing this procedure, as this gives you direct access to
the LEDs, which are very fragile.
You now should have full access to the lens assembly. This must be removed and the old lenses
must be replaced with the new lenses. The same assembly is to be reinstalled with the new
lenses in place and the process is complete.
disconnected from the fixture beforehand.
on the behalf of the user may void the IP-66 rating of this fixture.
4. Lens Assembly
2. LED glass UV cover
10
LED PCB
3/6/2009 9:53 AM