Master/Slave Linking; Id Addressing; Lens Assembly / Replacement - Chauvet COLORado 2 Tour User Manual

Master/Slave
Linking

ID Addressing

Lens Assembly
/ Replacement
COLORado™ 2 Tour User Manual Rev. 02b
The Master/Slave mode allows one COLORado™ 2 Tour (the master) running a
preconfigured program to control several other COLORado™ 2 Tour fixtures (the
slaves) without requiring a DMX controller. In this mode, all the slave fixtures will
operate in unison with the master fixture.
When in Master/Slave mode, the COLORado™ 2 Tour units link to each other by using
the standard DMX connection.
If you are not familiar with the Master/Slave connectivity, please refer to the DMX
Primer and DMX Connectivity sections in the Appendix chapter of this manual.
The Operation chapter of this manual provides detailed instructions on how to
configure the Master and Slave units.
The COLORado™ 2 Tour uses the ID Addressing feature to increase the number of
addressable fixtures in the same DMX universe when in the TOUR personality. Refer to
the Operation chapter in this manual to learn in detail how to configure the
COLORado™ 2 Tour fixtures when using ID Addressing.
The COLORado™ 2 Tour comes with the 15° lens assembly pre-installed from the
factory. However, there is an optional lens kit (CLENS3048) available as an accessory,
which will alter the beam angle of the fixture to 30º.
Follow the instructions below to change or replace the LED lens assembly.
•
Disconnect the fixture from the AC power before opening it.
•
The procedure below will give you direct access to the LEDs, which are very
fragile. Use maximum care when handling the lenses over the LED assembly.
A B
1) Remove the gel frame holder by removing the four thumbscrews (not shown).
2) Remove the front cover (A) by removing the eight Allen screws that hold it in place.
3) Remove the seal (B). Use caution, because the glass (C) is loose under this cover
and it may fall.
4) Remove the glass cover to gain access to the lens assembly (D).
5) After removing the glass cover, remove the six Phillips #2 screws that hold the lens
assembly in place.
6) Remove the existing lens assembly and replace it with the new lens assembly.
7) Reverse the process to complete the lens replacement.
After replacing the lenses, make sure that the fixture is completely sealed (IP66
rating) before installing it outdoors. Otherwise, you will void the fixture's
warranty.
C D
Setup
-7-