Korg TRITON Quick Start Manual page 23

7
4
1
2
3
EXIT MENU
Turn "IFX" Off. No insert effect will be applied
while sampling.
Press the OK button.
7
The TRITON Extreme will automatically set up the
following sampling parameters.
Take a minute to check that these are the settings that
have been made.
Input 1 "Level": 127, "Pan": L000
"BUS (IFX/Indiv.) Select": L/R
These parameters specify the input level and pan
from the INPUT 1, and select the L/R bus as the des-
tination.
"Source BUS": L/R
The sound sent to the L/R bus will be sampled.
"Trigger": Sampling START SW
Sampling will start when you press the SAMPLING
[START/STOP] key.
"Recording Level": +0.0
This is the default setting for external input record-
ing.
"Save to": RAM
The sound will be sampled to sample memory
(RAM).
"Mode": Mono-1
The sound of the internal L channel will be sampled
in mono.
The only thing we're going to change here is the
"Trigger" setting that specifies how sampling will
begin. For this example, let's set this so sampling
will begin when the input audio exceeds a specific
level.
A
8 9 H
5 6
2 3 PAUSE
0 /10's HOLD ENTER LOCATE
PROG BANK SMPL
COMBI BANK
B C D E
I J K L
PROG/COMBI BANK
SEQUENCER
REW FF TEMPO GATE
120
REC/WRITE START/STOP
40 240
Set "Trigger" to Threshold, and set "Level" to –30.
8
With this setting, recording will begin automatically
when the audio input reaches –30 dB or higher in
record-ready mode.
8
Set "Pre Trigger" to 005 ms.
With this setting, sample recording will begin 5 ms
earlier than (i.e., immediately before) sampling is
actually triggered, so that the very beginning of the
sound is not lost.
9 Adjust the recording level.
Use the rear panel [LEVEL] knob to adjust the
level appropriately.
Speak into your mic at the level you intend to
record, and adjust the level as high as possible with-
out allowing the "ADC OVERLOAD !!" (AD con-
verter input overload) warning to appear.
Press the SAMPLING [REC] key, and adjust the
"Recording Level" slider.
When you press the SAMPLING [REC] key, a level
meter will indicate the input level. Adjust the level
as high as possible without allowing the "CLIP!!"
warning to appear. Use the [VALUE] slider etc. to
adjust the "Recording Level" slider.
10 , 12,
2
MOSS GM
15 , 15
2
F G
9 , 9 ,
M N
2 5
10 , 15
1
ARPEGGIATOR
VELOCITY
SAMPLING
ON/OFF REC
3
1
START/STOP
9
3
19