Panel Displays Oh; Panel Displays; Troubleshooting Procedures; None Of The Components Operate (E.g. Pump, Light) - Jacuzzi J-270 Owner's Manual

on water for 30 seconds, then turn off. Reinstall filter cartridge and
check spa (sec. 11.1, page 25).
4. If problem persists, contact your authorized Jacuzzi dealer.

13.8 Panel Displays OH

Water temperature is above acceptable limits. DO NOT
ENTER SPA! Water temperature has reached 112˚F (44˚C)
and the low speed jets pump 1 and optional circulation
pump (when equipped) has activated to circulate water through heater.
Contact your authorized Jacuzzi dealer or qualified service technician.

13.9 Panel Displays - - -

The safety "Watchdog" software has been triggered and
the spa is deactivated. A problem has been detected
which could cause damage to the spa or its components.
Contact your authorized Jacuzzi dealer or qualified service
technician.

14.0 Troubleshooting Procedures

In the event your Jacuzzi
first review all the installation and operating instructions in this manual
and check the message on the panel display. If you are still not satis-
fied it is working properly, please follow the appropriate troubleshooting
instructions below. Note: If any of the supply cords to the accessories
are damaged, they must be replaced by authorized service personnel.
Contact your authorized Jacuzzi dealer or qualified service technician.

14.1 None of the Components Operate (e.g. Pump, Light)

Check the following:
1. Is there power to the spa?
2. Is the household circuit breaker tripped?
3. Contact your authorized Jacuzzi dealer or qualified service
technician.

14.2 Pump Does Not Operate But Light Does

Press the JETS 1 button:
1. If no water movement is detected, make sure power is going to the
spa and check the water level. If it does not solve the problem, con-
tact your authorized Jacuzzi dealer or qualified service technician.
2. The main jets pump 1 operates but no water flows to jets. Check the
following:
spa is not working the way it should, please
®
page 33