Panel Displays Oh; Panel Displays; Troubleshooting Procedures; None Of The Components Operate (E.g. Pump, Light) - Jacuzzi J - 200 J - 230 Owner's Manual

J-200
14.8

panel Displays oH

warnInG:
!
Causing severe inJury, burns, or welts.
Water temperature is above acceptable limits. Do noT
enTer spa! Water temperature has reached 112°F
(44°C) and the low speed jets pump 1 and optional
circulation pump (when equipped) has activated to circulate water
through heater. Contact your authorized Jacuzzi dealer or qualified
service technician.
14.9

panel Displays (- - -)

warnInG:
!
Causing severe inJury, burns, or welts.
Water temperature is above acceptable limits. Do noT
enTer spa! The safety "Watchdog" software has been
triggered and the spa is deactivated. A problem has been
detected which could cause damage to the spa or its
components. Contact your authorized Jacuzzi dealer or qualified service
technician.
15.0

troubleshooting Procedures

In the event your Jacuzzi spa is not working the way it should, please
first review all the installation and operating instructions in this manual
and check the message on the panel display. If you are still not satisfied
it is working properly, please follow the appropriate troubleshooting
instructions below.
note: If any of the supply cords to the accessories are damaged,
they must be replaced by authorized service personnel. Contact your
authorized Jacuzzi dealer or qualified service technician.
15.1

none of the Components operate (e.g. Pump, light)

Check the following:
1. Is there power to the spa?
2. Is the household circuit breaker tripped?
3. Contact your authorized Jacuzzi dealer or qualified service
technician.
42
rIsK oF HYperTHermIa (over-HeaTInG)
rIsK oF HYperTHermIa (over-HeaTInG)