Panel Displays Oh; Panel Displays; Panel Displays Blb; Troubleshooting Procedures - Jacuzzi J - 280 Owner's Manual

J-200
14.6

Panel Displays OH

WARNING:
!
CAUSING SEVERE INJURY, BURNS, OR WELTS.
Water temperature is above acceptable limits. DO NOT
ENTER SPA! Water temperature has reached 112°F (44°C)
and the low speed jets pump 1 has activated to circulate
water through heater. Contact your authorized Jacuzzi dealer or qualified
service technician.
14.7

Panel Displays (- - -)

WARNING:
!
CAUSING SEVERE INJURY, BURNS, OR WELTS.
Water temperature is above acceptable limits. DO NOT
ENTER SPA! The safety "Watchdog" software has been
triggered and the spa is deactivated. A problem has been
detected which could cause damage to the spa or its
components. Contact your authorized Jacuzzi dealer or qualified service
technician.
14.8

Panel Displays BLB

UV bulb needs to be replaced. The message will flash
between "blb" and the water temperature. The countdown
timer for the UV bulb needs to be reset (Section 11.6, page 31). A
new UV bulb can be purchased from a local Jacuzzi dealer.
15.0

Troubleshooting Procedures

In the event your Jacuzzi spa is not working the way it should, please
first review all the installation and operating instructions in this manual
and check the message on the panel display. If you are still not satisfied
it is working properly, please follow the appropriate troubleshooting
instructions below.
Note: If any of the supply cords to the accessories are damaged,
they must be replaced by authorized service personnel. Contact your
authorized Jacuzzi dealer or qualified service technician. Always insist
on genuine Jacuzzi replacement parts.
15.1

None of the Components Operate (e.g. Pump, Light)

Check the following:
1. Is there power to the spa?
2. Is the household circuit breaker tripped?
3. Contact your authorized Jacuzzi dealer or qualified service
technician.
46
RISK OF HYPERTHERMIA (OVER-HEATING)
RISK OF HYPERTHERMIA (OVER-HEATING)