NAPCO Security Command Center Operating Manual page 7

A R M I N G AW A Y : S E T T I N G T H E AL A R M W H E N L E AV I N G
SYSTEM TROUBLE
SYS/TRBL
L O W B A T T E R Y
E02 -00 SERVICE
SYS/TRBL
C A N ' T A R M S Y S T E M
P R E S S R E S E T K E Y
SYS/TRBL
EXIT TIME 060
PLEASE LEAVE NOW
CAN'T ARM SYSTEM
AREA X IN TROUBLE
System Trouble
If you attempt to arm with a "SYSTEM TROUBLE" display alternating with an indicated trouble
code (e.g. "E02-00" (low battery); see SYSTEM TROUBLE ERROR CODES), a 3-second tone will
sound at the keypad. The window will display "CAN'T ARM SYSTEM, PRESS RESET KEY". If
you cannot correct the problem immediately, pressing C will enable you to arm in this
condition. Be sure to call for service as soon as possible.
Area Arming (Optional)
Some systems may be divided, or partitioned, into smaller independent subsystems, which are
referred to as Areas. In a system that has been partitioned into multiple areas, one or more area
may be armed while others remain disarmed.
Manager's Mode (Optional)
The Manager's Mode allows the user to arm / disarm other areas in a partitioned system. To arm/
disarm a different area:
1. Press the numerical key representing the other area number.
Press G followed by
2.
Enter your User Code followed by Q to arm or disarm the area.
3.
Press G followed by
4.
Global Arming
(Optional) (Available only with the GEM-P3200/9600 panels)
To arm all areas simultaneously, press 9
To disarm all areas simultaneously, press 0
•
The User Code must be valid in all area(s).
•
If any zone is not secured, the keypad will display "CAN'T ARM SYSTEM, AREA X IN
TROUBLE", where X indicates the number of the Area in trouble. All faulted zones in the
respective area(s) must be secured or bypassed. Note: If a system trouble is indicated, the
system cannot be armed using this method.
U
. The keypad will now provide status and control of that area.
U
to return to the home area.
G and enter your code followed by
,
G and enter your code followed by
,
U
.
U
.
7