NAPCO Security Command Center Operating Manual page 35

Trouble System Trouble
Indication Condition
E10-NN Keypad Response Failure
Keypad Tamper
E11-NN
E12-NN Expansion Zone Module
Response Failure
E13-NN Expansion Module Tamper
Relay Board Response Fail-
E14-NN
ure
E15-NN RF Transmitter Tamper
Wireless Receiver Jam
E16-NN
E17-NN Receiver Tamper Condition
E18-NN KeyFob Transmitter Low
Battery
S Y S T E M T R O U B L E E R R O R C O D E S
Call installing company for service.
A keypad has been removed from the wall. Call installing company for service if
problem cannot be repaired.
Call installing company for service.
The cover has been removed from a zone expansion module. A problem has been
detected with an Expansion Module. Call installing company for service.
NN= Relay Board Number. Call installing company for service.
Wireless Transmitter Tamper Cover removed. NN=Transmitter Number. Call installing
company for service.
A problem has been detected with the wireless receiver. Call installing company for
service.
Call installing company for service.
The batteries (2) in the wireless KeyFob transmitter indicated are low and should be
replaced. The replacement battery is a #386 watch battery.
Warning: Replace batteries only with the same type as specified above. Use of another
battery may present a risk of fire or explosion. Do not recharge or disassemble battery, or
dispose of in fire.
Action
35