Window Sensor Removal - HP 650C User Manual

WINDOW SENSOR REMOVAL

To remove the window sensor, perform the following procedure:
1. Remove the right endcover.
2. Disconnect the window sensor cable connector from the front panel PCA.
3. Using a TORX T-8 screwdriver, remove the two screws that attach the window sen-
sor to the right sideplate and lift the sensor clear of the plotter. See Figure 6-13.
Don't cross-thread or over-tighten the screws when installing.
(C)C2858-49b
Window Sensor Cable
Figure 6-13.
Window Sensor
Removal and Replacement 6-19