Exmark Laser Z Ultra Vac Operator's & Parts Manual page 15

with the small filler plate included in the completing kit (Item 26). Use the hardware that
was removed when removing the large blocker plate (see figure 4). Failure to install a
blocker plate will create a thrown object hazard that could injure or kill bystanders,
or cause property damage. This modification should not be done if the Ultra Vac blower
will be mounted on a Lazer Z with a serial number of 260,000 or higher.
LAZER Z 52 UNITS WITH SERIAL NUMBERS
14. The front right deck stiffener must be trimmed for belt clearance on 52" Lazer Z units with
serial numbers less than 220,000. Measure and mark the deck stiffener (see figure 5).
Trim off the indicated portion of the stiffener. Touch up the trimmed area with Exmark red
touchup paint – P/N 1-850337.
LAZER Z 52 UNITS WITH SERIAL NUMBERS
FIGURE 4
LESS THAN 260,000 ONLY
FIGURE 5
LESS THAN 220,000 ONLY
15