Operation Instructions; Controls - Exmark Metro HP Operator's Manual

After clevis pin has been inserted, install hairpin into
hole on the clevis pin between the neutral lock/park
brake latch and drive lever (See Figure 11).
procedure on opposite side of unit.
d) Adjust brakes by adjusting wingnut on upper end of each
brake rod so that when brakes are engaged there is
approximately 1/4" of clearance between ends of drive
levers and handle grips (See Figure 10)
Note: Adjustment should allow the brakes to be engaged, yet
e) Squeeze the drive levers and move both neutral lock/park
brake latches into the neutral lock position. Mower
should move forward and backward freely, if not, readjust
as stated in Sections 3.11c and 3.11d.
3.12 Route the long unattached wiring harness lead, up the left
hand side of the handle and connect the two terminals (in
any order) to the operator presence control switch
terminals underneath the control console.
Fasten the lead to the handle with two small wire ties
from the bolt bag, one at the upper end of the handle
next to the console, and one at the very lower end of
the handle where it attaches to the fuel tank support.
3.13 If machine is shipped without muffler installed, install
muffler with hardware provided.
3.14 For Briggs and Stratton Engines install debris guard to top
of engine.
3.15 Service Engine: Refer to Engine Owner's Manual.
3.16 GREASE UNIT:
Refer to 5.1.13, for locations and grease amounts.
3.17 Follow pre-start instructions as outlined in 4.2.
3.18 Perform any needed adjustments as outlined in the
Adjustment Section.

4. OPERATION INSTRUCTIONS

4.1 Controls

4.1.1 Operator Presence Control (OPC) Levers: Located on the upper
handle assembly directly above the handle grips. When these
levers are depressed, the OPC system senses that the operator
Clevis Pin
Drive
Lever
Hairpin
DRIVE LEVER HARDWARE LOCATION
allow the neutral lock/park brake latches to be moved
into the park brake position, if not the brake
linkages must be adjusted again.
NOTE: UNIT IS NOT GREASED AT THE FACTORY.
FIG. 11
- 14 -
Repeat
Drive Linkage
Left Side
Shown
Reference for
Position Only
Neutral
Lock/Park
Brake Latch