Exmark Metro HP Operator's Manual page 28

FITTING
LOCATIONS
1. Caster Wheel Bearings
2. Caster Pivots
3. Blade Engagement Bellcrank
4. Drive Wheel Idler Arm
5. Clutch Arm Pivot
6. Cutter Deck Idler Pivots
7. Trans. Output Shaft Coupler
8. Cutter Spindles
(S/N's 150,000 to 159,999)
† Under severe cutting conditions, two pumps of
grease twice weekly may be more beneficial.
No. 5 (Clutch Arm Pivot)
Located Under Engine Deck
No. 7 (Trans. Coupler)
Located Below Fuel Tank Support
No. 4 & 7 (Idler Arm Pivots)
Disassemble and grease once a
Month under a "No Load" condition
c) Lubricate pivot points with a spray penetrating
lubricant as directed below.
PIVOT POINT
1. Blade Engagement Lever
d) Lubricate drive wheel hubs once a year. First remove
wheel, then remove hub cap. Lubricate the grease fitting
on each wheel hub with an SAE No. 2 multipurpose gun
grease, until grease appears through outer bearing.
Reinstall hub caps and wheels.
e) Replace 5-speed gearbox grease yearly. Use 18 oz. Of
Peerless grease (Part No. 788067). See Section 5.1.9.
5.1.14 Check spark plugs.
Service Interval:
a) Remove spark plugs, check condition and adjust plug gap
or replace with new plugs. See Engine Owner's Manual.
GREASE LUBRICATION CHART
INITIAL
PUMPS
12
2
1
2
1
2
2
10
SPRAY LUBRICANT CHART
160 hrs.
- 23 -
QUANTITY SERVICE
36" 48" 52" INTERVAL
2 2 2 Daily
2 2 3 Daily
1 1 1 Weekly
2 2 2 Weekly
1 1 1 Weekly
1 1 1 Weekly
2 2 2 Weekly
2 3 3 † Weekly
NO. OF
SERVICE
PLACES INTERVAL
1 Weekly