Engine Will Not Start - Exmark Metro HP Operator's Manual

b) Check deck support pins.
same hole position on each support pin.
c) Check deck support alignment and check mounting brackets
to be sure all bolts are tight.
d) Check blades tip to tip for straightness.
be within 3/16", or one blade width from being in line.)

6.3 ENGINE WILL NOT START.

a) Check that choke is in the "ON" position for a cold
engine or in the "OFF" position for a warm engine. See
4.3.2.
NOTE: Kawasaki engines may need to be choked even when warm.
b) Make sure the key switch is in the "ON" position
(B&S and 17 HP Kawasaki engines only).
c) Make sure transmission is in "true neutral" position.
(See section 3.10c).
d) Check that the blades are disengaged and the blade switch
is depressed.
e) Check that there is fuel in the tank and that the fuel
valve is open.
f) Check that the spark plug wire(s) are properly connected.
g) Check for loose or faulty wiring connections. If it is
necessary to disconnect wire connectors, Do Not pull on
the wires while disconnecting.
h) Check for corrosion at all wiring connections.
Even minor corrosion may cause a faulty connection.
Clean connector terminals thoroughly with electrical
contact cleaner, apply dielectric grease and reconnect.
• • • •
NOTE: After carefully checking the above steps, attempt
to start the engine. If it does not start, contact your
authorized Exmark service dealer.
ENGINE TROUBLESHOOTING
• • • •
• • • •
CAUTION
It is essential that all operator safety
mechanisms be connected and in proper
operating condition prior to mower use.
CAUTION
When checking starting problems, be
sure to keep body, hands and clothes
away from areas where moving parts
can suddenly engage.
CAUTION
When performing maintenance, servicing
or repairing the unit, allow the engine
ample time to cool down. Serious burns
can result from hot metal.
- 28 -
Hairpin clips must be in the
(They should