Torque Requirements; Operation Instructions; Controls - Exmark Laser Z XS Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
2.11.4 Tread Width: (center to center of tires, widthwise)
2.11.5 Wheel Base: (center of caster to center of drive tire)
2.11.6 Curb Weight:

2.12 TORQUE REQUIREMENTS

Bolt Location
Cutter Housing Spindle Nut (secured with threadlocker) 160-185 ft-lbs. (217-251 N-m)
Blade Mounting Bolt...........................................................55-60 ft-lbs. (75-81 N-m)
Sheave Mounting Nut ..................................................90-110 ft-lbs. (122-149 N-m)
Engine Deck/Front Frame Mount Bolts ..............................30-35 ft-lbs. (41-47 N-m)
Anti-Scalp Roller (See Figure 6)
Engine Mounting Bolts ......................................................30-35 ft-lbs. (41-47 N-m)
Wheel Lug Nuts .............................................................90-95 ft-lbs. (122-129 N-m)
Wheel Motor Mounting Bolts............................................72-77 ft-lbs. (98-104 N-m)
Wheel Hub Slotted Nut .............................................minimum 125 ft-lbs. (169 N-m)
Rollover Protection System (Roll Bar) Mounting Bolts .......30-35 ft-lbs. (41-47 N-m)
Clutch Retaining Bolt (secured with threadlocker)........................55-60 ft-lbs. (N-m)

3. OPERATION INSTRUCTIONS

3.1 CONTROLS

3
.1.1
3.1.2
Drive Wheels
60" Deck 41.9 in. (106.4 cm)
66" Deck 45.9 in. (116.6 cm)
72" Deck 45.9 in. (116.6 cm)
60" Deck 56.0 in. (142.2 cm)
66" Deck 57.6 in. (146.3 cm)
72" Deck 60.2 in. (152.9 cm)
60" Deck 1510 lbs. (685 kg)
66" Deck 1560 lbs. (708 kg)
72" Deck 1610 lbs. (730 kg)
Nyloc Nut ..................................................................30-35 ft-lbs. (41-47 N-m)
Hex Capscrew...........................................................50-55 ft-lbs. (68-75 N-m)
Familiarize yourself with all controls before operating the mower.
Motion Control Levers: Located on each side of the console. The left lever
controls the flow of hydraulic oil from the left hydrostatic pump to the left drive
wheel motor. The right lever controls the flow of hydraulic oil from the right
hydrostatic pump to the right drive wheel motor.
IMPORTANT: To begin movement (forward or backward) the operator must
be in the seat, the brake lever must be disengaged (pushed down) before
the motion control levers can be moved in or the engine will shut off.
When levers are centered in the T-slot the drive system is in the neutral position.
With levers moved out in the T-slot the drive system is in the neutral lock position
(See Figure 2).
www.mymowerparts.com
Casters
37.3 in. (94.7 cm)
42.3 in (107.4 cm)
47.3 in. (120.1 cm)
- 14 -
Torque