Exmark Metro HP Operator's Manual page 15

3.8 Route the throttle cable along the right side of the upper
handle, under the fuel tank support, and position the cable
on the left side of the engine (Kaw & Kohler) or to the
right side of engine (B&S) .
Attach throttle cable to engine:
For Kohler and Kawasaki engines with "positive" detents
in throttle cable for the full throttle and idle positions.
a) Position the throttle control lever (on console) in the
full throttle (but not choke) position. You will feel a
detent when the throttle lever is approximately 3/4" from
the upper end of the slot (this is full throttle position).
b) Loosen clamp on engine control plate (See Figures 2, 3 & 4).
Attach inner wire of the throttle cable to the control
plate lever and position cable clamp, do not tighten clamp.
FIG. 1
UPPER HANDLE MOUNTING
FIG 2
KOHLER SPEED CONTROL
(THROTTLE CABLE HOOK-UP)
FIG 3
14 HP KAWASAKI SPEED CONTROL
(THROTTLE CABLE HOOK-UP)
- 10 -