Removing the glass panes
•
Remove the 3 panes of glass starting with pane 1.
•
When removing pane 3 ensure that the 2 rubber supports
are removed before cleaning. Do not misplace them!
Cleaning the glass panes
Clean with a damp cloth.
Do not use scouring agents or abrasive sponges
as these could damage the reflective surface.
Dry thoroughly before reassembly.
Replacing the glass panes
•
Replace the glass panes back into the door starting
with pane 3.
•
Ensure this pane is placed into the correct slot and that
the 2 rubber supports are in place.
•
Next replace pane 2. There is a reflective coating on
this pane. This coating is indicated by a circle printed
on its surface. ensure this circle is in the same corner as
pictured below.
Circle in this corner
•
Replace pane 1 ensuring the black screening is facing
inwards towards the oven.
Replacing the top door trim
Replace the trim ensuring the clips snap into the 2 location holes.
open the oven door fully and return the locating tab on
each hinge to the original closed position.
CLEANING
35