Required S-Gw Ingress Context Configuration Information - Cisco ASR 5000 Series Administration Manual

Serving Gateway Configuration
Required Description
Information
Gateway IP address Used when configuring static IP routes from the management interface(s) to a specific network.
Security The name or names of the security administrator with full rights to the system.
administrator name
Security Open or encrypted passwords can be used.
administrator
password
Remote access The type of remote access that will be used to access the system such as telnetd, sshd, and/or ftpd.
type(s)

Required S-GW Ingress Context Configuration Information

The following table lists the information that is required to configure the S-GW ingress context on an eGTP S-GW.
Table 4. Required Information for S-GW Ingress Context Configuration
Required Description
Information
S-GW ingress An identification string from 1 to 79 characters (alpha and/or numeric) by which the S-GW ingress context is
context name recognized by the system.
Accounting An identification string from 1 to 63 characters (alpha and/or numeric) by which the accounting policy is
policy name recognized by the system. The accounting policy is used to set parameters for the Rf (off-line charging)
interface.
S1-U/S11 Interface Configuration (To/from eNodeB/MME)
Interface name An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface is
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
IP address and IPv4 or IPv6 addresses assigned to the interface.
subnet Multiple addresses and subnets are needed if multiple interfaces will be configured.
Physical port The physical port to which the interface will be bound. Ports are identified by the chassis slot number where
number the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17.
A single physical port can facilitate multiple interfaces.
Gateway IP Used when configuring static IP routes from the interface(s) to a specific network.
address
GTP-U Service Configuration
GTP-U service An identification string from 1 to 63 characters (alpha and/or numeric) by which the GTP-U service will be
name recognized by the system.
OL-22986-01
Configuring the System as a Standalone eGTP S-GW ▀
Cisco ASR 5000 Series Serving Gateway Administration Guide ▄