Cisco ASR 5000 Series Administration Manual page 61

Serving Gateway Configuration
Creating an S-GW Ingress Context
Use the following example to create an S-GW ingress context and Ethernet interfaces to an MME and eNodeB, and bind
the interfaces to configured Ethernet ports.
Notes:
This example presents the S1-U/S11 connections as a shared interface. These interfaces can be separated to
support a different network architecture.
The S1-U/S11 interface IP address(es) can also be specified as IPv6 addresses using the
command.
Creating an eGTP Ingress Service
Use the following configuration example to create an eGTP ingress service:
OL-22986-01
Configuring the System as a Standalone eGTP S-GW ▀
Cisco ASR 5000 Series Serving Gateway Administration Guide ▄