Viewing Dhcp Leased Clients; Configuring Rstp (Cisco Rv180W) - Cisco RV180 Administration Manual

Configuring Networking
Configuring the LAN (Local Network) Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 2
NOTE
STEP 1
STEP 2
Cisco RV180/RV180W Administration Guide
To add a new device:
Click Add.
Enter the MAC address of the device that will download configuration files.
Enter the filename of the file that the device should download.
Click Save.

Viewing DHCP Leased Clients

You can view a list of endpoints on the network (identified by MAC address) and
see the IP address assigned to them by the DHCP server. The VLAN of the
endpoint is also displayed.
Choose Networking > LAN > DHCP Leased Clients (LAN).
The list of endpoints is displayed; you cannot edit this list.

Configuring RSTP (Cisco RV180W)

Rapid Spanning Tree Protocol (RSTP) is a network protocol that prevents loops in
the network and dynamically reconfigures which physical links should forward
frames. When RTSP is configured, multiple paths to the root networking node are
created. Backup paths are automatically disabled unless the active path to the root
node is down. If that occurs, a backup path is enabled.
RSTP is not aware of virtual LANs (VLANs) in a network, so it is not recommended
for use in a network with VLANs.
To configure RTSP:
Choose Networking > LAN > RSTP.
Check Enable to enable RSTP.
2
39