Using The Getting Started Page - Cisco RV180 Administration Manual

Introduction

Using the Getting Started Page

Using the Getting Started Page
Cisco RV180/RV180W Administration Guide
The Getting Started page displays the most common Cisco RV180/RV180W
configuration tasks. Use the links on this page to jump to the relevant configuration
page.
By default, this page appears when you start the Device Manager. However, you
can change this behavior by checking Don't show this on start up at the bottom
of the page.
Initial Settings
Run Setup Wizard
Configure WAN
(Internet) Settings
Configure LAN
(Local Network)
Settings
Configure Wireless
Settings (RV180W only)
Add VPN Clients
Quick Access
Upgrade Device
Firmware
Backup/Restore
Settings
Click this link to launch the Setup Wizard.
Click this link to open the Internet Setup page.
See Configuring the IPv4 WAN (Internet),
page 24.
Click this link to open the LAN Configuration page.
See Configuring IPv4 LAN (Local Network)
Settings, page 32.
Click this link to open the Basic Settings page.
See Configuring Basic Wireless Settings,
page 63.
See Configuring VPN Users, page
Click this link to open the
Firmware Upgrade page.
See Upgrading Firmware, page
Click this link to open the
Backup and Restore page.
See Backing Up and Restoring the System,
page 151
1
121.
156.
17