ResMed C-Series User Manual page 5

Connecting the C-Series Heated Humidifier
WARNING
!
Make sure the flow generator is switched off and unplugged at the
•
power outlet before connecting or disconnecting the humidifier.
Always remove the water chamber before connecting or disconnecting
•
the humidifier and the flow generator.
1. Disconnect the flow generator power cord from the socket at the rear of the flow
generator.
2. Fit the connector seal to the air outlet on the flow generator. Ensure the connector
seal is fully seated over the air outlet.
3. Place the humidifier base on a firm, level surface near your bed at a level lower than
your sleeping position. Ensure the surface is not sensitive to heat and moisture, or
use a protective mat.
4. Align and place the flow generator on the humidifier base.
5. Connect the (black) humidifier signal cable into the signal cable socket, and the
(gray) power transfer cable into the power socket at the rear of the flow generator.
Do not attempt to use the system unless both cables are connected to the flow
generator.
6. Use the power cord supplied with the C-Series Tango flow generator and connect it
to the humidifier power cord socket.
7 . Plug the other end of the power cord into a power outlet. When the combined
C-Series system is powered, the green indicator lights on the flow generator and
humidifier turn on.
Attaching and Detaching the Water Chamber
WARNING
!
Take care when handling your humidifier. Allow ten minutes for the heater
plate and any excess water to cool.
2
connector seal